PLURIJET 80-100

Flow rate up to 130 L/min (7.8 m³/hr)
Dynamic head up to 50m

OPERATING LIMITS

Suction lift up to 9m
Fluid temperature between -10°C up to + 40°C
Maximum ambient temperature + 40°C
Maximum working pressure 6 bar
Continuous service S1

PLURIJET 90-130-200

Flow rate up to 200 L/min (12 m³/hr)
Dynamic head up to 97m

OPERATING LIMITS

Suction lift up to 9m
Fluid temperature between -10°C up to + 40°C
Maximum ambient temperature + 40°C
Maximum working pressure 10 bar
Continuous service S1

PUMP INSTALLATION AND APPLICATIONS

These pumps are suitable for handling clean water and fluids which are not chemically aggressive to the pump components, even when air is mixed with the liquid.

THEY ARE EXTREMELY RELIABLE, ECONOMICAL AND SIMPLE TO USE, BEING PARTICULARLY SUITABLE FOR DOMESTIC APPLICATIONS SUCH AS THE AUTOMATIC DISTRIBUTION OF WATER FROM SMALL AND MEDIUM-SIZED SURGE TANKS, WATERING GARDENS, ETC.

These pumps should be installed in a covered area, protected against the weather.

PERFORMANCE

The wide range of pumps in the Plurijet series suit a variety of applications.

• high heads with respect to power requirements;
• flat operating and power absorption curves, giving moderate curve variations with respect to large variations in delivery demand;
• high tolerance of the presence of entrained air in the pumped liquid;
• suction capacities up to 9 meters.

Curve tolerance according to ISO 2548.

STRUCTURAL CHARACTERISTICS

• Cast iron and stainless steel AISI 304 PUMP BODY (cast iron up tp 0.75kW) with UNI ISO 228/1 gas threaded suction and delivery ports.
• Technopolymer IMPELLERS (approved for drinking water).
• AEN 10088-3-1.4104stainless steel MOTOR SHAFT
• Ceramic and graphite MECHANICAL SEAL.
• MOTOR: the pumps are coupled directly to an asynchronous, high efficiency PEDROLLO induction motor of suitable size which is quiet running, closed and externally ventilated, suitable for continuous duty. INSULATION class F
  A thermal cutout device (motor protector) is incorporated in single phase motors.

Three phase motors require an adequate external motor protector connected according to current standards.

• PROTECTION IP 44.
• REGISTERED MODEL.

NOTE: It is always advisable to install a foot valve on installations that involve a suction lift.