Banner
Home  //  Water Pumps Multi-Stage  //  2-5CR
2-5 CR
Print
E-mail

2-5CR
Download 2-4CR pdfBuy Pedrollo Water Pump


DOWNLOAD PDF FOR FULL DETAILS INC PERFORMANCE CURVES AND DIMENSIONS

Flow rate up to 120 L/min (7.2 m³/h)
Dynamic head up to 50 m

COMPACT, EXTREMELY QUIET, HIGH OUTPUT, LOW CONSUMPTION PUMPS WITH STAINLESS STEEL BODY, FOR DOMESTIC & COMMERCIAL USE.

OPERATING LIMITS

Suction lift up to 7 m
Fluid temperature up to + 40°C
Maximum ambient temperature + 40°C

PUMP INSTALLATION AND APPLICATIONS

These pumps are suitable for handling clean water and fluids which are not chemically aggressive to the pump components.

THEY ARE EXTREMELY RELIABLE, QUIET AND VIRTUALLY MAINTENANCE-FREE, FINDING MANY USES IN DOMESTIC AND LIGHT COMMERCIAL APPLICATIONS.
THEIR PERFORMANCE CHARACTERISTICS AND LOW NOISE MEANS THAT CR PUMPS ARE PARTICULARLY SUITED TO WATER SUPPLY APPLICATIONS (INCLUDING BOOSTING DOMESTIC MAINS PRESSURE*) AND FOR LARGE OR MULTIPLE SHOWER APPLICATIONS.

These pumps should be installed in a covered area, protected against the weather.

PERFORMANCE

The working principle of multistage pumps gives high pressures without excess capacity while retaining the clear advantages of centrifugal pumps. Pumps in the 2/5 CR range have the following features.

  • stable characteristic curves (very high ratio between maximum and minimum head values);
  • very low noise levels at any duty point;
  • low power consumption for the head values achieved;
  • good suction capacities.

Curve tolerance according to ISO 2548.

STRUCTURAL CHARACTERISTICS

  • AISI 304 Stainless steel PUMP BODY with UNI ISO 228/1 gas threaded suction and delivery ports.
  • AISI 304 stainless steel back plate serving also as mechanical seal housing.
  • IMPELLERS, centrifugal radial flow type, made of General Electric Noryl technopolymer (approved for drinking water).
  • AISI 416 stainless steel MOTOR SHAFT.
  • Ceramic and graphite MECHANICAL SEAL
  • MOTOR: the pumps are coupled directly to an asynchronous, high efficiency PEDROLLO induction motor of suitable size, which is quiet running, closed and externally ventilated, suitable for continuous duty. INSULATION class B.
    A thermal cut-out device (motor protector) is incorporated in single phase motors.

Three phase motors require an adequate external motor protector connected according to current standards.

  • PROTECTION IP 44.
  • CONSTRUCTION AND SAFETY STANDARDS in compliance with EN 60 335 -1, (IEC 335-1, CEI 61-150), EN 60034-1, (IEC 34-1, CEI 2-3)
  • REGISTERED MODEL

*Installations must comply to Water Bye-laws in the UK.